Fill the gap or hole in the NX8 2

[BABUGOUDA]

Hello All,

I need one information to know please

Is there any command which is equivalent to fill surface in catia V5.
I use N-sided surface if i have a non planer closed curve. and i use patch if there is non planer hole in the surface .
But other than this if any body knows other commands please let me know. because i am not finding exactly the alternate to fill surface in catia V5

I am using Nx8

Thx
BGD

 

[JurgenKreisel]

Are you talking about a hole in a sheet body?
If so we use the "Trim and Extend" function. Set type to "By Distance" and put in a value larger than what would be needed to close the hole.

 

[jerry1423]

Is this surface part of a solid body?

 

[JohnRBaker]

If you're running NX 8.0, have you tried using the new 'Delete Edge' function? This will allow you to delete the edges of an opening, thus closing the 'hole'.

This function can be found at...

Insert -> Trim -> Delete Edge...

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[BABUGOUDA]

Hello all.

Thanks for your answers.

@JurgenKreisel
Trim and extend works for the regular shape hole. if it irregular it wont work(please correct me if i am wrong)

@JohnRBaker .

Yes delete edge works perfectly. however i need to fill the closed 3D curve like we do in catia v5 with Fill command .
Now to achieve this i am using N-Sided surface. Please let me know which are the other comands other than through curve mesh( complicated when a curve is a single) and N-Sided surface.
I am using the UG NX8
I have attached the UG Nx part File

Thanks in advance
Thanks

BGD