Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations Ron247 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fiberglass GS&T Long Part

Status
Not open for further replies.

successtrends

Mechanical
Aug 10, 2012
1
I have a part .138"thk X 9.0"W X 438" L made of Fiberglass composite mat'l. The supplier is sending parts in with vertical waves over the Horiz length of the part. If I put a FLATNESS tolerance on this part how would this look in the control frame? Should datum points be place along the part? If so, how would this Control Frame look.
+-.025 over 36" sections? Exterior part that requires aesthetic appearance to be minimal.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor