Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Fellows Taper
- Thread starter Occupant
- Start date
This has been discussed here before, but unfortunately it appears that no one had an answer.
See:
Timelord
See:
Timelord
O,
Fellows Shank cutter tapers:
#1 morse, with 0.4750" Gage dia, by 1.000" long.
#2 morse, with 0.7000" Gage dia, by 1.500" long.
Fellows Short Taper, 1.0625" Gage dia, by 1.500" long.
Fellows Long Taper, 1.0625" Gage dia, by 2.250" long.
All with appopriate drawbar thread in the ends.
IIRC, Ash gear used to have the data in their catalog and also carried a good selection of adapters.
Cheers,
Winston H.
Fellows Shank cutter tapers:
#1 morse, with 0.4750" Gage dia, by 1.000" long.
#2 morse, with 0.7000" Gage dia, by 1.500" long.
Fellows Short Taper, 1.0625" Gage dia, by 1.500" long.
Fellows Long Taper, 1.0625" Gage dia, by 2.250" long.
All with appopriate drawbar thread in the ends.
IIRC, Ash gear used to have the data in their catalog and also carried a good selection of adapters.
Cheers,
Winston H.
- Status
Similar threads
