Can anybody tell me a software which I can use for fault calculations in electrical systems, conductor sizing and coordination analysis using ANSI standards. I know EDSA. But it is too expensive for me and if anybody knows a place from where I can get it installed.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Fault calculation software
- Thread starter kitha
- Start date
Check out EasyPower at Also do a search of the Electric Power Engineering forum for other software including possibly some free software.
- Status
Similar threads
- Locked
- Question
