Fastener assembly placing 96 joints take too much time, is it normal? NX10/TC10

[IvanNX]

Placing 96 fastener assemblies took little less than a hour, then changing properties for washers in top stack took more than hour and a half, is that normal?
If not normal (and I am very much sure it is not normal) what can be a cause of long time?

_____________________________
Enjoy your work and have fun!

 

[daluigi]

FYI: we are seeing that poor performance since NX 75 + Teamcenter 10 and what Siemens called at the time "a better integration of the two products". It has been so bad for every command that involves a massive live update of the Teamcenter Structure (typically adding/replacing fasteners) that we have finally decided to skip all constraints for those items...

 

[petulf]

Hmmm weird adding fasteners to an assembly should not trigger teamcenter structure updates, as bom structure synchronization should only happen during save.

 

[IvanNX]

Thank you daluigi.
So that is good and bad in same time. Good that it is not me making some stupid mistake, bad is that I would really like to have constrains on it, but with this amount of time used to place them with constrains I think I will skip them too. But it is minus for project.


_____________________________
Enjoy your work and have fun!