Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Factor C to be used in design of elliptical flat plates

Status
Not open for further replies.
FabianoRibeiro

FabianoRibeiro

Mechanical
Joined
Feb 26, 2009
Messages
35
Location
BR
Dear all,

In the case of a elliptical flat plate to be used as internal cover of a manway, what value should be used as factor C for the calculation of the required thickness of the plate?

I looked in Fig. PG-31 of ASME code Section I and I'm not sure which one is applicable to this case.

Best regards.
 
Status
Not open for further replies.

Similar threads

mariolucas75
  • Question Question
thickness tolerance of piping Vs plates
Replies
1
Views
6K
MJCronin
MJCronin
JoshRanch
  • Locked
  • Question Question
What seismic codes should be used for Vessels to be installed on Offshore Platforms?
Replies
4
Views
2K
jt1234
jt1234
MHS1988
  • Locked
  • Question Question
Flat Top of Cyclone Filter
Replies
1
Views
2K
pierreick
pierreick
KD007
  • Question Question
SA-193 Gr.B7M bolt material used in Wet H2S service is not passing requirement of UG44b clause.
2
Replies
20
Views
10K
r6155
r6155
L
  • Locked
  • Question Question
Flat head calculations
Replies
0
Views
920
Lukas_1990
L

Part and Inventory Search

Sponsor

Back
Top