Mirrorman44,
The short answer is NO, but you can section the faceted body to create curves from which you can possibly rebuild the geometry. Later version of NX Studio Tools contained a function which assists in that process, but it nevertheless requires that you work with curves to extract the geometry.
On the off chance that the faceted body was retrieved from a JT file then you may be able to retrieve the equivalent of a Parasolid, but this only occurs because the data originated in NX. Check out File>Properties>JT File>Extract Exact Data. If you hadn't opened a JT file in the first instance tabs will be absent or greyed out.
Best Regards
Hudson
www.jamb.com.au
Nil Desperandum illegitimi non carborundum