extrude solid/ surface

[kenppy]

The number of times that I hit extrude make the section and then realize that I didn't pick surface, then figure do I close this and start again or go back to sketcher and close the section then pick surface, then resketch....

Is there a config option that would make the default extrude section a surface by default.

Just asking.

 

[Atropos89]

You could set up a mapkey to start an extrude as a surface.

 

[tobbo]

I believe that in wf1 , when you left the section open, it was automatically a surface.... but that option was later removed. Doesnt help you thoo...


Mapkey as mentioned above is a nice way.


//Tobias

 

[ksavsani]

Mapkey is the best way to figure out this problem.....