Expressions 1

[pencilgeek]

I know I can create If/Else formulas within expressions, and have been able to make them funtion. My question is, can I do If/Then statements? I want to drive the location of an endpoint in a sketch from any one of multiple points. For example:

If A=1 Then B=X
If A=2 Then B=Y
If A=3 Then B=Z

And so on. How can I make this happen? This is just one feature of a model and I don't want to get into part families.

Thanks

 

[MickyV007]

Have a look at this thread,

http://www.eng-tips.com/viewthread.cfm?qid=196582

Best regards,

Michaël.

NX7.5.4.4 + TC Unified 8.3
Win 7 64 bit

 

[pencilgeek]

Thanks Michael, I tried to search the threads but I guess I didn't get the right info in. That thread told me what I needed to know.

 

[jerry1423]

There are two search buttons above, use the one that is under the title of this post.