Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Excluding Parts of an Assembly from Stress Analysis

  • Thread starter Thread starter Reinhold
  • Start date Start date
Status
Not open for further replies.
R

Reinhold

Guest
Does anyone know if Mechanica allow part of an assembly to be excluded from a stress analysis such that their only function is to transfer reaction loads?



If not, then can parts be turned off in the results window so that the stress plot only shows the stresses of the remaining parts?
 
Have you tried creating a simplified rep?
 
Status
Not open for further replies.

Similar threads

jasongBSME
  • Locked
  • Question Question
Converting from Pro/Mechanica to Creo Simulate
Replies
0
Views
801
jasongBSME
jasongBSME
DKrol
  • Locked
  • Question Question
Export STEP file from Creo to Solidworks
Replies
1
Views
811
goeasyon
goeasyon
S
Dynamic Analysis of Theo Jansen walking mechanism
Replies
0
Views
37K
Sai Rakesh
S
T
Pro mechanica - create a mesh from imported points (nodes)
Replies
1
Views
24K
Twig Studio
T
T
Angle analysis feature to be used as a dimension in a drawing table
Replies
1
Views
14K
annad_m_s
A

Part and Inventory Search

Sponsor

Back
Top