Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ETABS CENTRE OF RIGIDITY 1

Status
Not open for further replies.

engineer327

Civil/Environmental
Oct 28, 2021
1
Hello,
I am trying to obtain Centre of rigidity for a 2 storey frame in 2D. However in the "SHOW TABLES > ANALYSIS RESULTS > STRUCTURE OUTPUT > OTHER OUTPUT ITEMS > CENTRES OF MASS AND RIGIDITY", only Centre of mass is displayed. Centre of Rigidity is not displayed. Th
Capture_ksgqyy.png
e Etabs model is attached for reference.
How can I resolve this issue?
Thanks in Advance!!!
 
Replies continue below

Recommended for you

I believe that you need to assign the diaphragm as "rigid" and then tick the box in the "set cases to run" (btm left hand corner).
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor