Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ETABS Beam/Column and Joint Shear N/A

Status
Not open for further replies.

IngDiaz

Structural
Joined
Jan 7, 2016
Messages
1
Location
DO
Good day everyone,
After modelling a 20 stories building I realized that the Beam/Column and Joint Shear are not being checked, instead, it appears "N/A". My columns are defined as Sway Special Frames and all my beams are made of concrete. Can anyone explain me the reason behind this, or give me any tip to look for the root of the problem. I'd sincerely appreciate it.

Thank you.
 
Can you confirm that the slabs meshing is proper and that columns are connected to the corners of slab elsments and not on their edges or inside them.

Jason McKee
proud R&D Manager of
Cross Section Analysis & Design
Software for the structural design of cross sections
Moment Curvature Analysis
Reifnorcement Design etc.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top