ahmedhegazi
Structural
- Jul 5, 2007
- 92
Hi All,
Etabs 2015 has the option for assigning Wall Hinge which can be used in Performance based design .
the problem i notes is what value is assign of reinforcement to the wall hinge , i always get Hinge PM interaction curve based on 0.4 % reinforcement , did anyone experience this problem before?
Regards,
Etabs 2015 has the option for assigning Wall Hinge which can be used in Performance based design .
the problem i notes is what value is assign of reinforcement to the wall hinge , i always get Hinge PM interaction curve based on 0.4 % reinforcement , did anyone experience this problem before?
Regards,