Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ESD Susceptibilty Symbol on assembly drawings
- Thread starter mfgspike
- Start date
To the best of my knowledge, there is no set guideline for the size of the symbol as long as it is visible. If you are creating the drawing for an outside customer you may ask them wht thier standards are. You can refer to this website for more information
- Status
Similar threads
- Question
- Locked
- Question