Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

equations needed 1

Status
Not open for further replies.

jjfa

Mechanical
Joined
Apr 13, 2004
Messages
9
I´m designing a mechanical piece used to induce the movemente in a spooler. This piece has sombre steel plates that area welded to a main one, I would like to know which equations shiold i use in order to estimate the lenght of the welding, according to the loads that are present (torque)
 
If you need to design weldments, and figure out the required length of welds, it would be hard to do better than getting "Design of weldments" or "Design of Welded Structures" from Lincoln Electric, by Omer Blodgett. They have all the info you need and are dirt cheap for a good book like that.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top