EPDM 2013.......Anyone using it? 1

[PhoenixDynamometer]

Hello all,
We are contemplating jumping over 2012 (SW & EPDM) and going right to 2013. Does anyone have any feedback on EPDM 2013 stability?

Thanks,
PD

http://www.phoenixdyno.com

Home of the world's most accurate and repeatable dynamometers, dynamometer accessories, and data acquisition & control software.

 

[CorBlimeyLimey]

You may have to wait a while longer to find out. EPDM13 is only at Pre-release 1 stage.
i.e. Not for production, testing only.

 

[PhoenixDynamometer]

Hi CBL,

I know about the release status but I was hoping for any feedback, even feedback about the pre-release version. 2012 was such a disaster we uninstalled and went back to 2011 SW and EPDM

http://www.phoenixdyno.com

Home of the world's most accurate and repeatable dynamometers, dynamometer accessories, and data acquisition & control software.

 

[AnnaWood]

Only way to find out is to do a test install for yourself.

What works great for us may be a disaster for your engineering environment.

FWIW,

Anna Wood
SW2012 SP4, Windows 7 x64

http://www.renderbay.com

http://www.solidmuse.com

http://www.phxswug.com

 

[ctopher]

I will find out in a couple months.
We will be upgrading from SW 2011 to SW 2013, and PDM 2011 to EPDM 2013.

Chris
SolidWorks 11
ctopher's home
SolidWorks Legion

 

[clarmr]

We will be installing EPDM this upcoming week so I will share my thoughts on the install, implementation etc soon. I am very excited bc I have only used PDM and this EPDM is a very powerful tool.



Chandler

 

[saf12]

So, now that we are in May. What have all of you encountered?... We are embarking on implementing SWX EPDM, I'm looking for some feed back.

 

[snowshoe2]

Been using EPDM 2013, no concerns.