Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ENGRAVING ON A CURB SURFACE 1

Status
Not open for further replies.

valdo

Aerospace
Joined
Aug 3, 2004
Messages
10
Location
CA
Is it possible to do engraving on a part that has been created with a (curb)surface?
The Wrap Text command doesen't work only on cylindrical,conical,extruded or revolved face.
I have SW2004SP0
 
Wrap will work on some of those types of features. I just tried it on a cylindrical and extruded surface... No problem. Conical and revolved surfaces are not supported. SW04 SP4.1

Your going to have to follow your other thread. to get the workaround.

thread559-100606

Regards,

Scott Baugh, CSWP [pc2]

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top