Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

EMI suppression due to soldering joints

Status
Not open for further replies.

Neiltowers

Automotive
Joined
Jul 17, 2001
Messages
3
Location
GB
I was curious to know whether the modification of a resistor with a higher value on a surface mount device by hand soldering would affect EMC at high frequencies?
 
Suggestions:
1. Yes, it might.
2. It depends on the circuits, parameters, frequency, signal waveform and shielding.
 
Thankyou for your reply, do you have any links where i can further investigate this?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top