Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

EMI suppression due to soldering joints

Status
Not open for further replies.
Neiltowers

Neiltowers

Automotive
Joined
Jul 17, 2001
Messages
3
Location
GB
I was curious to know whether the modification of a resistor with a higher value on a surface mount device by hand soldering would affect EMC at high frequencies?
 
Sort by date Sort by votes
Suggestions:
1. Yes, it might.
2. It depends on the circuits, parameters, frequency, signal waveform and shielding.
 
Upvote 0 Downvote
Thankyou for your reply, do you have any links where i can further investigate this?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

dogbural
  • Locked
  • Question Question
soldering (dry joint)
Replies
3
Views
2K
Gr8blu
Gr8blu
electricpete
  • Locked
  • Question Question
[cross post] Portable antenna-based EMI detection of arcing at wound rotor motor slip rings?
Replies
0
Views
253
electricpete
electricpete
PaulKraemer
  • Question Question
Looking to replace inductive prox switch in demanding application
Replies
11
Views
5K
3DDave
3DDave
Y
  • Locked
  • Question Question
Trying to figure out cause of malfunction
Replies
7
Views
4K
danw2
danw2
SA07
  • Question Question
How to protect against frequent breakdown of soft starters at a water pumping station?
Replies
10
Views
11K
RedSnake
RedSnake

Part and Inventory Search

Sponsor

Back
Top