Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ellipse gear
- Thread starter nercor
- Start date
- Thread starter
- #3
If it's not an elliptical gear - the low a/b ratio seems to indicate that - then there should be a center mounting hole with a dowel hole next to it in the direction of the longer axis to line the pre-machined outer contour with the EDM code und the part can be clamped through the center hole.
- Status
