Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ECAD import problem

Status
Not open for further replies.

jdt020471

Mechanical
Joined
Aug 30, 2002
Messages
42
Location
GB
I have imported an EMN & EMP file into Wildfire and ALL the components
appear as they should, in the 'blocky' state. My problem arises when I
look at the ECAD_HINT.ADD file. This file does not contain all the
components shown in the EMP library file. So when I use the ECAD_HINT.ADD
file to replace the 'blocky' parts with actual models, I only get a few
components replaced.

I also get the following messages in the ECAD_IN.LOG file:

Warning: Previous placement instructions of the component
with placement name <CN1> were totally replaced at import.

I get this warning for every component that is not in the ECAD_HINT.ADD
file. Anyone know what this means and how I can osrt it out.

Thanks in advance

Jeff
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top