Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drive shaft Paint

Status
Not open for further replies.
Elroyjet

Elroyjet

Automotive
Sep 8, 2003
4
Hay, I am working on a paint project for steel driveshafts. The question is if the part sees a 300F oven for 17 minutes, and the part temp is data packed at 279F. Then what is the temp that I have to PPAP to?
 
Status
Not open for further replies.

Similar threads

roseda
  • Locked
  • Question
Disc deceleration with flexible shaft 3
Replies
12
Views
1K
roseda
roseda
ksw100
  • Locked
  • Question
Assessing Lubrication Adequacy in Cam Shaft and Lifter Design 1
Replies
2
Views
857
SwinnyGG
SwinnyGG
sbmar
  • Locked
  • Question
Hydraulic Drive vs. Direct drive vs, Diesel Electric Drive -- Overall Efficiency Comparison 3
Replies
8
Views
2K
Zenithund
Zenithund
pmbrunelle
  • Locked
  • Question
Low-throttle driveline oscillations
Replies
19
Views
3K
BrianPetersen
BrianPetersen
shitalyog
  • Locked
  • Question
Can we use front drive line with rotating 180 degree at Rear side? What will be impact on mounts?
Replies
7
Views
903
CWB1
CWB1

Part and Inventory Search

Sponsor

Back
Top Bottom