Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drilling into type 321ss 2

Status
Not open for further replies.
Santo928

Santo928

Mechanical
Joined
May 4, 2012
Messages
1
Location
US
Need info on drill type, speed, pilot size drill for a 3/4 in. Hole drilled through a flange at 90 deg. To flange face for a pressure tap. Thickness of flange is 6 in. Concern about chips and wear on drill. Also suggest coolant type and rate.
 
Sort by date Sort by votes
Do you need a hole that big just to sense the pressure?



Mike Halloran
Pembroke Pines, FL, USA
 
Upvote 0 Downvote
How many of these holes and on what type of machine? Are there any other parameters that you are concerned about?
 
Upvote 0 Downvote
Here is what I would use.

Drill Kennametal Dynapoint with thru coolant. Kennametal Catalog # K210A07500HP
Speed / Feed 270 SFM and .010 IPR

This Sir is all you will need for tooling. Do not spot drill for the hole just drill it.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

D
  • Question Question
Drilling oversized and drilling undersized on Fanuc machine?
Replies
5
Views
7K
SamuelPrescott4
SamuelPrescott4
Claypoolsbass
  • Locked
  • Question Question
Press fit a steel pin into aluminum
Replies
3
Views
2K
John Donlan
John Donlan
STEAKMAN17
  • Locked
  • Question Question
Does anyone know what this type of cutter this is used on or who makes it? WaterJet? Laser?
Replies
4
Views
391
IFRs
IFRs
privaate
  • Locked
  • Question Question
zinc plate ASTM - B 633 type 2
Replies
3
Views
405
chez311
chez311
Chris_W
  • Locked
  • Question Question
Micro drilling help needed
Replies
5
Views
662
btrueblood
btrueblood

Part and Inventory Search

Sponsor

Back
Top