ManOfSteel8357
Materials
Is there an equation that relates a drill bit geometry to it's axial cutting speed given material type and drill RPM?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Drill Bit Geometry
- Thread starter ManOfSteel8357
- Start date
- Status
ornerynorsk
Industrial
You cannot exceed the helix angle of the tip edge relief in feed. Not without a lot of horsepower and a very tough drill bit material.
Practical application is considerably less than this :>)
It is better to have enough ideas for some of them to be wrong, than to be always right by having no ideas at all.
Practical application is considerably less than this :>)
It is better to have enough ideas for some of them to be wrong, than to be always right by having no ideas at all.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question