Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drawing view question

Status
Not open for further replies.

davidB026

Mechanical
Joined
May 1, 2007
Messages
26
Location
US
I am was wondering, when you are in a drawing and I am adding reference datums to my drawing view. I am able to create them but how can I reposition them?
 
Change the selection filter to datums and then select and move the required datum.

The selection filter is at the bottom righ hand of the screen.
 
Nevermind I figured it out. I have to go the properties and change it to a datum then I am able to click and drag the plane name
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top