Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

drawing. edge thinkes

Status
Not open for further replies.

gang1

Industrial
Joined
Aug 10, 2003
Messages
12
Location
RU
Hello, clevers

I'd like to thiken some of the visible edges on my drawing views made for MFG operations. There's a background for such a curious stuff - suppose I'd like to emphasize something (to show the area that is currently being machined). Does anyone know how to be a success in that point. Any advises are of demand and would be greatfully accepted.

Ilya
 
You can create draft geometry with tools\Use edge and then modify the line type of the draft geometry. Or, try tools\offset to make additional lines. I use the latter to show the region where a profile tolerance applies.
 
Thank you for your generous help, guys
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top