Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Draftsight question 2

Status
Not open for further replies.

hiyosilver

Computer
Joined
Jun 29, 2014
Messages
1
This may be trivial, but is there a quick way to intersect & trim two lines?? Thanks!
 
Have you used the Fillet command with a radius of .000? This will cause 2 lines to intersect and trim all at once. Sylvia
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top