Its been years since I used UG, but an old boss asked me to help with something quick.
If I start NX 7.5 and choose a new size E drafting, and set scale to 1:8, what have I done wrong as a rectangle that is nearly as large as the drawing shows the literal size when dimensioned, ~40" wide?
I am attempting to manually sketch out a floor plan of a room. With that in mind, I'd expect on a 44" wide drawing set to 1:8 scale, the same rectangle would be roughly 320" wide when dimensioned?
Thanks for any help, I am rusty as heck, not to mention I never drafted either when I was using NX
ferme
If I start NX 7.5 and choose a new size E drafting, and set scale to 1:8, what have I done wrong as a rectangle that is nearly as large as the drawing shows the literal size when dimensioned, ~40" wide?
I am attempting to manually sketch out a floor plan of a room. With that in mind, I'd expect on a 44" wide drawing set to 1:8 scale, the same rectangle would be roughly 320" wide when dimensioned?
Thanks for any help, I am rusty as heck, not to mention I never drafted either when I was using NX

ferme