Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting border not at 0,0

Status
Not open for further replies.

TheRealDeal55

Automotive
Joined
Jun 1, 2012
Messages
25
Location
US
Gents,
I am using NX Ideas version 5. I have completed a drawing using
drafting package. It seems entire drawing has shifted down and
is being cut of by main border. Any way of repositioning main border
so entire drawing can be seen?
Thanks,
 
Try asking here -> forum561

If you do post your question there, please red flag this one for removal.

"Know the rules well, so you can break them effectively."
-Dalai Lama XIV
 
Better yet use the Siemens: I-deas forum for a version that old.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top