Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dodgy regeneration error.

  • Thread starter Thread starter SW
  • Start date Start date
S

SW

Guest
When I regenerate an assembly I get a error saying:



WARNING: Model for a variable reference pattern is missing.



How do I find the route of the problem? I've tried doing a ModelCHECK
analysis but it doesn't get me anywhere. Anyone got any ideas?



Thanks,





Sam
 
Sam-


I see it's been some time since you posted this problem and hopefully you have found a solution. If not I have a possible solution:


If you are working with assemblies try to open one part at a time and regenerate each part you will find the problem. More than likely you have some feature referenced from one part to another, only something has changed that the software can't find the reference.





Sonics
 

Part and Inventory Search

Sponsor

Back
Top