Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Do yo see this post?

Status
Not open for further replies.
JimmyJazz13

JimmyJazz13

Aerospace
Joined
Nov 7, 2013
Messages
6
Location
CA
Sorry for this post but I've written a few post here without getting any answers. Since most posts get reply I just want to make sure I'm doing everything ok publish my post.


Thanks!
 
Sort by date Sort by votes
Yes you're fine. Many posts here go unanswered, for any number of reasons I suppose. Probably because internet.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

G
  • Locked
  • Question Question
How to create this feature in abaqus part modelling?
Replies
3
Views
1K
FEA way
FEA way
Oakjelly21
  • Locked
  • Question Question
How do I close a section in Abaqus sketch?
Replies
1
Views
515
FEA way
FEA way
Oakjelly21
  • Locked
  • Question Question
How do I make imported sketches into 2D planar geometry
Replies
2
Views
312
Oakjelly21
Oakjelly21
ALK2415
  • Locked
  • Question Question
[ Post Punching of flat slab ]
Replies
3
Views
250
FEA way
FEA way
hussain98
  • Locked
  • Question Question
Too many attempts made for this increment
Replies
1
Views
366
FEA way
FEA way

Part and Inventory Search

Sponsor

Back
Top