Display Borders problem in drafting

[Mitchel123]

HI Guys,

In drafting the model display border has increased which also increased the cross section line. I dont want to move the cross section line manually as I have drawing consists of 10 pages. Please suggest if there is any way to make the display borders to its original position.

I think looking at the attached picture will give a better understanding what I am talking about.

Thanks

regards

Mitchel

 

[JohnRBaker]

Are you saying that somehow the borders have gotten 'larger' from one release to the next? If so, which release to what?

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[Mitchel123]

I have been working on NX7.5 and the model is created from scratch in 7.5. The display border was fine until today, as soon as I open the drafting the border seems large and its large in all 10 sheets of drawings, which has made all the cross sections outside the border as shown in the picture.

I dont know what happen !! May be there must be some kind of option available ?

Thanks

Mitchel

 

[JohnRBaker]

So you're saying that nothing has changed, like installing NX updates or anything like that, eh?

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[Mitchel123]

I am sure I haven't updated anything.