Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

din standards

Status
Not open for further replies.

jimmyt

Marine/Ocean
Joined
Apr 25, 2003
Messages
1
Location
US
I am doing installation drawings for a pair of Wartsila engines. One of the connections is a size 00 18 din 2353 compression fitting. Is this for 3/4" id or od tubing?
 
Maybe you need to change the connector , and use one you can get local.
Sure there is a female NPT or BSP thread on the block.

If the DIN is 18, it mean 18 mm outside diameter.
So you never can get a good fit with a 3/4 outside diameter.



Pardal
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top