Dimensioning a section view

[yayaya25]

I have this section view in my drawing of a 3D part and I'm trying to put a diameter dimension and the only dimension arrows that I can get form it is only one arrow I want the two outside arrows with the two lines showing the diameter. It's an iso view of the part. Right now I have juat the single arrows pointing at the holes with the dimension on them I it so it's easier to read I have been messing with teh properties, but no luck. ANyone have any suggestions? Thanks!

 

[CorBlimeyLimey]

Select the dimension and in the Dimension Manager that opens select the Inside (middle) option in the Witness/Leader Display section.

The adjust dimension arrows and placement to suit.