MatejK
Student
- Mar 29, 2021
- 1
Hi Everyone,
I would like to simulate two different heat sources (one continous wave laser, and one pulsating laser) with different geometries of the heat source. The model I want to simulate is additive manufacturing, where wire is added on the top of a base plate with heatsources from before mentioned lasers.
I believe this can not be done in DFLUX as it only offers one moving heat source.
Therefore I would like to explore UMDFLUX subroutine more, but there is hardly any available information on it. Could anyone help me out, with starting out in the mentioned plugin and subroutine?
Thank you very much!
I would like to simulate two different heat sources (one continous wave laser, and one pulsating laser) with different geometries of the heat source. The model I want to simulate is additive manufacturing, where wire is added on the top of a base plate with heatsources from before mentioned lasers.
I believe this can not be done in DFLUX as it only offers one moving heat source.
Therefore I would like to explore UMDFLUX subroutine more, but there is hardly any available information on it. Could anyone help me out, with starting out in the mentioned plugin and subroutine?
Thank you very much!