Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

DesignModeler "Glue"

Status
Not open for further replies.

qwicker

Mechanical
Joined
Jun 19, 2007
Messages
67
Location
US
Hi all,

I'm just starting out using DesignModeler with workbench 12. I know the classic version very well, and I am looking for the "glue" command. It seems that I am looking for Connect in DM...When I use this command it seems to connect the areas OK but I dont think the lines and nodes are connected. I am doing this for a 2D axisymmetric analysis of concentric cylinders and dont want to have a contact region.

Any ideas?

Thanks
 
The glue operation in Design Modeler can be performed in two ways: grouping all bodies together in the same part or using the Boolean operation UNITE.

Regards,
Steve
 
Yes, I was looking for the create new part command
 
There is no commmand. You just have to select all bodies and then create a part..

That easy.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top