Design Table supression

[vacuumdesigner]

Ok guys, everything seems right here, so I can't figure out what code I have screwed up.

I'm trying to supress certain parts in configurations with a design table. SW07 will accept my table without any erros, but when I set a component to supressed in the assembly DT nothing happens.

The current code I have entered looks like this:

$state@3214-0600-000<1>
S

With these two values in separate cells, one above the other, then that PN should be suppressed, correct?

 

[vacuumdesigner]

Update:

Some of my code for suppression works just not all of it. Currently from what I see the ones I have trouble with have some excel formula assocaited with them in some way.

 

[CorBlimeyLimey]

Yes it should work if the rest of the DT is correctly formatted.

Are you sure you are looking at the correct config?
Did you type "$state@3214-0600-000<1>" or double-click on the component? Typo?

 

[CorBlimeyLimey]

"excel formula" ???

 

[vacuumdesigner]

Ok, I feel like an idiot now.

I accidently copied the code for supression twice in the design table. So I told it to supress in one section of the table, and then, a little farther down the table I told it to unsupress it again.

 

[CorBlimeyLimey]

So problem RESOLVED then!

 

[vacuumdesigner]

Yes indeed