Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Design Table & Threads

Status
Not open for further replies.
xgrigorix

xgrigorix

Specifier/Regulator
Joined
Aug 24, 2005
Messages
66
Location
US
I have a component which has a 1/4-20 UNC-2B thread running through it. I would like to set up a design table to drive multiple configurations. I cannot for the life of me get the table to drive the thread, too. Everything else comes in fine. Is this even possible?

SW2006 SP5.1
 
Sort by date Sort by votes
As far as I know you can't control that in a Design table. You could control the Dimensions.

Regards,

Scott Baugh, CSWP [pc2]
faq731-376
 
Upvote 0 Downvote
I decided to create all of the different sized threads & use the design table to suppress & unsuppress as needed.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

CAD2015
  • Question Question
Electrical Harness Design..............
Replies
2
Views
770
CAD2015
CAD2015
Treads0322
  • Locked
  • Question Question
Linked properties in General Table
Replies
6
Views
1K
SBaugh
SBaugh
Rodger Furey
  • Locked
  • Question Question
Solidworks Configurations - file size & non-dimensional differences
Replies
2
Views
593
SSCon
SSCon
jassco
  • Locked
  • Question Question
Unable to use dual dimension in feature control frames (GD&T) in Solidworks 2023
Replies
5
Views
2K
3DDave
3DDave
Ebbie22
  • Locked
  • Question Question
Design Table Issue
Replies
1
Views
461
SBaugh
SBaugh

Part and Inventory Search

Sponsor

Back
Top