lowellsmoger
Mechanical
I'd like to define my own equation to be plotted as a colored contour on my model but cannot seem to find information online regarding the process for doing this.
Please advise.
Thanks
Please advise.
Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Defining a custom contour equation
- Thread starter lowellsmoger
- Start date
- Status
Hello, mtbmx88!
Please find in ANSYS help description of the following commands:
DNSOL, DESOL, DETAB
that allow you to redefine (modify) the nodal and element results. Use this commands in an input that allow you to replace existing results with results obtained by your equation.
Contour plots of modified results will be available using the post1 commands PLNSOL, PLESOL, PLETAB.
Success!
Juzz
Please find in ANSYS help description of the following commands:
DNSOL, DESOL, DETAB
that allow you to redefine (modify) the nodal and element results. Use this commands in an input that allow you to replace existing results with results obtained by your equation.
Contour plots of modified results will be available using the post1 commands PLNSOL, PLESOL, PLETAB.
Success!
Juzz
- Status