Default settings in hole wizard 1

[designer22]

Is it possible to change the default settings in the hole wizard (Part modeling)

Please see the attached image, need to change the neck chamfer angle of the Counter bore hole from 0 to 90.

Thanks

 

[macduff]

Can't you save it as a favorite?

Colin Fitzpatrick (aka Macduff)
Mechanical Designer
Solidworks 2008 SP 4.0
Dell 490 XP Pro SP 2
Xeon CPU 3.00 GHz 3.00 GB of RAM
nVida Quadro FX 3450 512 MB
3D Connexion-SpaceExplorer

 

[CorBlimeyLimey]

Just type in the required angle. The HW will remember the setting.

 

[designer22]

Thanks CorBlimeyLimey,

I am just beginner to SW and trying to learn.
This was part of my learning.

Thank you once again..