Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dear Expert, Kindly advise the P

Status
Not open for further replies.

kunjhon

Mechanical
Jun 15, 2020
12
SA
Dear Expert,

Kindly advise the P No of the material 90/10 CuNi, UNS C70610 to BS 2871
I didn't find out from the table QW-422, ASME section 9.

Kindly advise and support. It is needed prior to PWPS preparation
 
Replies continue below

Recommended for you

There is none.
Good website for checking p#'s.
[link pnumbers.com]Link[/url]
 
From my experience with 90/10, similar welds are done with the same filler. Dissimilar uses a nickel based alloy which may explain why there is no P number as copper and nickel are in separate groups.

Why aren't you brazing this?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top