Hi, I'm hoping ya'll can help me. I've been looking around various sites for a while, and can't seem to find a simple way to create a datum tag on a feature, in this case, the outer diameter of an injection molded part. I want to tag the OD similar to the way shown in the attached image. Right now, creo is only letting me tag datum planes and axis. Thanks!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Datum Tag on Feature
- Thread starter bucknast
- Start date
- Status
Similar threads
- Locked
- Question