Need help on applying Datums to a fixture I'm creating. The part is a 2.00 x 2.00 x 36.00 lg piece with a 7" radius across the top that runs the length of the piece. I need to control straightness of the piece to .003. The radius is also a critical feature. I'm new to all this so any suggestions would be appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Datum Planes
- Thread starter sshug
- Start date
I can't picture the configuration of the part you described to be able to help answer your question. But, they say that a picture is worth a thousand words ..... so if you could email me a sketch of the part you need to apply datums and tolerances to, I'll do what I can to try and help you out. Send the email to:
mpwright@ticnet.com
Look forward to hearing from you!
GDTGUY
mpwright@ticnet.com
Look forward to hearing from you!
GDTGUY
- Status
Similar threads
- Locked
- Question