Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

D1.1 code book 2010 version

Status
Not open for further replies.

dbernard2012

Petroleum
Joined
Jan 14, 2014
Messages
10
Location
US

RE; Table 2.9. Can someone explain this table? question below.

Question : What is the Z loss dimension for pre-qualified PJP T-,Y-K-
Connector what a groove angle of 50 degrees using short circuiting transfer GMAW in the horizontal position?
 
Did you look at the clause and the figures that are referenced? The figures on the last page of clause 3 pretty much says it all.

Best regards - Al
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top