Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CUTTING CONDITION FOR 2.5 KW MAZAK 16PL

Status
Not open for further replies.
kalm4

kalm4

Structural
Joined
Sep 16, 2004
Messages
1
Location
AU
IM CURRENTLY OPERATING A MAZAC 2.5 KW MK2
AND HAVING HEAPS OF TROUBLE CUTTING 16MM MILD STEEL PLATE
I AM TOLD THAT THIS MACHINE CAN DO IT BUT THE CUT IS JUST NOT CONSISTENT ANY HELP WOULD BE MUCH APPRECIATED
USING 7.5 LENS 2MM TIP WITH 3D CUTTING HEAD
THANKYOU
 
Status
Not open for further replies.

Similar threads

Garrett Green
  • Locked
  • Question Question
Mazak Laser having trouble cutting 1/2" Material
Replies
0
Views
1K
Garrett Green
Garrett Green
B
  • Question Question
Will there be problems with the cutting section if the laser cutting speed is too fast or too slow?
Replies
3
Views
451
IRstuff
IRstuff
Hans H.
  • Locked
  • Question Question
Anti spatter for laser cutting?
Replies
1
Views
1K
Rex Hang
Rex Hang
Pablo_Garcia
  • Locked
  • Question Question
Seeking Guidance: Choosing the Right Laser Cutting Machine for Beginners
Replies
0
Views
922
Pablo_Garcia
Pablo_Garcia
Majidtaherkazemi
  • Locked
  • Question Question
amada cutting laser
Replies
0
Views
342
Majidtaherkazemi
Majidtaherkazemi

Part and Inventory Search

Sponsor

Back
Top