Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cutting 45 degree 10" Sch. 40 Buttweld Elbow into 22.5 degree 10" Elbow

Status
Not open for further replies.
AlbertaMecchie

AlbertaMecchie

Mechanical
Joined
Feb 17, 2021
Messages
19
Location
CA
I am having a very hard time finding a 22.5 degree 10" Sch. 40 elbow.

Is there anything in the ASME codes advising against cutting a 45 degree elbow down into a 22.5 degree elbow and prepping the cut end for buttwelds.

And this is for use on a slurry line, so is not technically pressure pipe.
 
Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

MJN2
  • Locked
  • Question Question
Elbow Stress Analysis
Replies
4
Views
872
MJN2
MJN2
Singhnishesh
  • Locked
  • Question Question
Weld-o-let on elbow
Replies
10
Views
1K
racookpe1978
racookpe1978
FPPE
  • Locked
  • Question Question
ASME B31.3 - 1/2" elbow obtained from bended tube in ASME SB-165 N04400
Replies
4
Views
450
david339933
david339933
Piper Mike
  • Locked
  • Question Question
24" Pipe Attached Directly to 10" Fired Heater Outlet Nozzle
Replies
4
Views
435
Piper Mike
Piper Mike
Suradach
  • Question Question
Tie-In Issue: 10”x10S SS316L to 24”x10S SS316L – Weld Clearance & Flange Type
Replies
14
Views
6K
LittleInch
LittleInch

Part and Inventory Search

Sponsor

Back
Top