Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
cutting 0.125" laminated acrylic
- Thread starter NCLaser
- Start date
laserman16
Industrial
Well for starters you'll need to preset your z gap due to the fact the non contact will not reconize the material. You may wish to score the laminate prior to processing the job.
You can try using 600 watt/500 freq/100 duty. This is a medium setting set by Mazak. For the most part you will need to simply do some test cutting to figure out what works best for your machine.
You can try using 600 watt/500 freq/100 duty. This is a medium setting set by Mazak. For the most part you will need to simply do some test cutting to figure out what works best for your machine.
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question