Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Current load in 3D problems

Status
Not open for further replies.
murla

murla

Electrical
Joined
Oct 3, 2007
Messages
1
Location
SI
Hello,

when using SOLID97 or SOLID117 elements, is it always necessary that the condition divJ=0 is satisfied? Can I simulate current in a solid conductor, which is completely surrounded by air and does not form a closed loop? Both ends of the conductor are within the air enclosure and there is no symmetry, so that loads can't be applied on symmety planes.

Thanks!
 
Status
Not open for further replies.

Similar threads

H
  • Locked
  • Question Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
3K
karachun
karachun
andradesilva
  • Locked
  • Question Question
thin-walled 3D solid to a shell
Replies
1
Views
466
Stick.
Stick.
shiraz883
  • Locked
  • Question Question
Stresses increase on adding thermal boundary conditions/ thermal load
Replies
1
Views
474
SWComposites
SWComposites
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X

Part and Inventory Search

Sponsor

Back
Top