Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CROSS THREADING FORMULA

  • Thread starter Thread starter -
  • Start date Start date
Status
Not open for further replies.

Guest
I WAS WONDERING IF ANYONE KNOWS IF THERE IS A FORMULA TO FIGURE OUT THE MAXIMUM OR MINIMUM ANGLE AT WHICH A BOLT WILL CROSS THREAD INTO A NUT? I THINK IT HAS SOMETHING TO DO WITH THE DIA. OF THE BOLT THREADS AND THE DIA. OF THE NUTS THREADS.

THANK YOU
 
Status
Not open for further replies.

Similar threads

M
  • Locked
Cladding Area - Threading Possibilities
Replies
0
Views
856
Manigandan Manickam
M
Packermanfan
  • Locked
  • Question Question
UNEF Threading Above 1-11/16"?
Replies
4
Views
393
Brian Malone
Brian Malone
ESTinker
  • Locked
  • Question Question
Guideline or formula on slack to remove timing belts off of pulleys
Replies
2
Views
461
BEMPE16524
BEMPE16524
JD_WTG
  • Locked
  • Question Question
Laminate in Shear Cross Pin Bearing Strength
Replies
2
Views
223
SWComposites
SWComposites
engineerfin
  • Locked
  • Question Question
Roller Bearing Cross ref
Replies
1
Views
98
JJPellin
JJPellin

Part and Inventory Search

Sponsor

Back
Top