Creating non-mittered flanges

[pablbalbi]

Hello! I´m having a doubt when creating flanges along multiple edges. If i select two edges as in the pictured the get automaticaly mittered. Is there a way to make them as drawn in red in the picture, without having to edit each flange profile?
I remember that when i was using autodesk inventor you get a button to configure each meeting flange, and change if is mittered or one over another.

Thanks

 

[JMirisola]

If there is, I haven't found it. One would think, though, that there should be that ability. I'd suggest sending in an enhancement request.

Jeff Mirisola, CSWE
My Blog

 

[hititfaster]

I've used joints like that before, and I couldn't find any 'automatic' tool to create them. I ended up manually cutting and adjusting.

I agree with the above - it would be a cool enhancement.